troubleshooting
Problem | Possible Cause | Solution |
Engine will not start. | No spark. | Check spark. Remove spark plug. |
|
| Reattach the spark plug cap and lay |
|
| spark plug on metal cylinder. Pull the |
|
| starter rope and watch for spark at |
|
| spark plug tip. If there is no spark, repeat |
|
| test with a new spark plug. |
| No fuel. | Push primer bulb until bulb is full of fuel. |
|
| If bulb does not fill, primary fuel delivery |
|
| system is blocked. Contact a servicing |
|
| dealer. If primer bulb fills, engine may |
|
| be flooded, proceed to next item. |
| Engine is flooded. | Remove spark plug, turn product so |
|
| spark plug hole is aimed at the ground. |
|
| Rotate the choke dial to “RUN” position |
|
| and pull starter cord 10 to 15 times. This |
|
| will clear excess fuel from engine. Clean |
|
| and reinstall spark plug. Pull starter |
|
| three times with choke dial at “RUN”. If |
|
| engine does not start, rotate choke dial |
|
| to “FULL CHOKE” position and repeat |
|
| normal starting procedure. If engine still |
|
| fails to start, repeat procedure with a |
|
| new spark plug. |
| Starter rope pulls harder now than | Contact a servicing dealer. |
| when new. |
|
|
|
|
Engine starts but will not accelerate. | Engine requires approximately three | Allow engine to completely warm up. If |
| minutes to warm up. | engine does not accelerate after three |
|
| minutes, contact a servicing dealer. |
|
|
|
Engine starts but will only run at high | Carburetor requires adjustment. | Contact a servicing dealer. |
speed at half choke. |
|
|
|
|
|
Engine does not reach full speed and | Check lubricant fuel mixture. | Use fresh fuel and the correct |
emits excessive smoke. |
| lubricant mix. |
| Air filter is dirty. | Clean air filter. Refer to Cleaning the Air |
|
| Filter Screen earlier in this manual. |
| Spark arrestor screen is dirty. | Contact a servicing dealer. |
|
|
|
Page 17