assembly
Installing the vacuum tubes
See Figures 5 - 6.
WARNING:
Rotating impeller blades can cause severe injury. Always stop the engine before opening the vacuum door or installing/changing tubes. Do not put hands or any other object into the vacuum tubes while they are installed on the unit.
To install the vacuum tubes:
Place the unit on its side to allow easy access to the vacuum door.
Secure the upper and lower vacuum tubes together by aligning the raised locking tabs with the raised slots.
Align the screw holes in the lower tube with the raised slot in the upper tube. Adjust the length and secure with supplied screws.
Using a flathead screwdriver, rotate the screw securing the vacuum door counterclockwise to release.
Place the lip on the upper vacuum tube beneath the hinge of the vacuum door. This will allow the screw on the other side to seat in the threaded hole.
Using a flathead screwdriver, tighten the screw to secure.
To remove the vacuum tubes, reverse the above steps.
vacuum
tubes
screwscrew
Fig. 5
| hinge |
threaded | vacuum |
hole | |
| door |
| upper |
| vacuum |
| tube |
| Fig. 6 |
