Homelite UT10942D manual Maintenance, UT10927D, UT10946D, Page

MAINTENANCE

14.Remove all slack from the chain using the chain tensioning screw. Place a slotted screwdriver in the slot and turn clockwise until the chain seats snugly against the bar with the drive links in the bar groove.

UT10942D	CHAIN TENSIONING
	SCREW

15.Lift the tip of the guide bar up to check for sag.

16.Release the tip of the guide bar and turn the chain tensioning screw 1/2 turn clockwise. Repeat this process until sag does not exist.

17.Hold the tip of the guide bar up and tighten the bar mounting nuts securely.

The chain is correctly tensioned when there is no sag on the underside of the guide bar, the chain is snug, but it can be turned by hand without binding. Ensure that the chain brake is not set.

Note: If chain is too tight, it will not rotate. Loosen the bar nuts slightly and turn the tension adjuster 1/4 turn counter- clockwise. Lift the tip of the guide bar up and retighten the bar mounting nuts securely. Ensure that the chain will rotate without binding.

UT10927D	Fig. 49
UT10946D

CHAIN TENSIONING

SCREW

Fig. 50

Fig. 48

Fig. 51

Page 24