OPERATION
WASHING WITH DETERGENT
See Figures 18 - 19.
Use only detergents designed for pressure washers; house- hold detergents, acids, alkalines, bleaches, solvents, flam- mable material, or industrial grade solutions can damage the pump. Many detergents may require mixing prior to use. Prepare cleaning solution as instructed on the solution bottle.
nRemove the cap from the detergent container and pour detergent in the container. Replace cap on container.
nRotate the spray selector on the
Nozzle to either the short range detergent [
] or long range detergent [
] setting.
nSpray the detergent on a dry surface using long, even, overlapping strokes. To prevent streaking, do not allow detergent to dry on the surface.
NOTE: To use a detergent bottle, open the detergent container cap. Next, remove the filter from the end of the injection hose then slide the hose out of the cap. Place the injection hose filter back on the hose and place the hose in the bottom of the bottle.
For long range detergent application:
With the nozzle installed on the spray wand and the engine shut off, rotate the spray selector to the long range detergent [
] setting.
For short range detergent application:
With the nozzle installed on the spray wand and the engine shut off, rotate the spray selector to the short range deter- gent [
] setting.
Before shutting off the engine:
nPlace the injection hose in a bucket of clean water.
nFlush for 1 - 2 minutes (spray clear water through the spray wand).
nShut off the engine.
NOTE: Shutting OFF ( O ) the engine WILL NOT relieve pres- sure in the system. Pull trigger to release water pressure.
RINSING WITH THE PRESSURE WASHER
nTurn off the pressure washer and shut off the water supply. Pull trigger to release water pressure.
nEngage the lock out on the trigger handle by pushing up on the lock out until it clicks into the slot.
nRotate the spray selector on the
nWhen using these settings, test a small area first to avoid surface damage.
nStart at the top of the area to be rinsed and work down, overlapping the strokes.
MOVING THE PRESSURE WASHER
See Figure 20.
NOTE: Never lift or carry this product using the handle and never place the unit in any position other than upright on its wheels.
nTurn the pressure washer off and ensure the fuel valve is closed.
nPull the handle up until the handle release knob snaps into the locking position (if not already up and locked). Ensure the lock is secured in the frame hole before moving.
nTilt the machine toward you until it balances on the wheels then roll the machine to the desired position.
