MAINTENANCE
CLEANING THE DECK NOZZLES
See Figure 14.
There are two deck nozzles located under the cleaning deck. If these nozzle become clogged, it may be necessary to clean them.
To clean nozzles:
nUnplug the pressure washer.
nTurn off the pressure washer and shut off the water supply. Pull the trigger to release water pressure.
nTilt the cleaning deck backwards to expose the spray bar.
nWith a wrench, remove the holders from each end of the spray bar then lift the nozzle from the holder.
nUsing a straightened paper clip or nozzle cleaning tool (not provided), free any foreign materials clogging or restricting the nozzle.
nUsing a garden hose, flush debris out of nozzle by back flushing (running the water through the nozzle backwards or from the outside to the inside).
nSlide the nozzle back into the holder.
nPlace the holder and the spray bar and retighten.
CHANGING THE HIGH PRESSURE FILTER
See Figure 15.
Once you have cleaned the deck nozzles, if the water still doesn’t flow freely from the spray bar, it may be necessary to replace the high pressure filter.
To replace the filter:
nUnplug the pressure washer.
nPlace a flathead screwdriver in the cleaning deck inlet plug. The slot in the top of the filter will cause it to turn so it can be lifted out of the machine.
nOnce the filter is removed from the inlet plug, replace it with a new filter (not included).
nUsing a flat head screwdriver, turn the filter until it can no longer be seen over the top of the inlet plug.
STORING THE PRESSURE WASHER
Allow 30 minutes of “cool down” time before storing the machine. Store in a dry, covered area where the weather can’t damage it.
It is important to store this product in a
NOTE: Use of a pump saver will give you better perfor- mance and increase the life of the machine.
12 — English
