OPERATION
CAUTION:
Striking any raised obstacle which using with the clean- ing deck will damage the unit. If contact does occur and causes vibration when operating the pressure washer, stop and replace the spray bar. Continuing to operate the unit without replacing the spray bar could result in serious injury or damage to the unit.
NOTE: See figure 14 for the location of the spray bar.
MOVING THE PRESSURE WASHER
nTurn the pressure washer off. Point nozzle in a safe direc- tion and pull trigger to release water pressure.
nStore the spray wand in the cleaning deck.
nTilt the machine toward you until it balances on the wheels then roll the machine to the desired position.
MAINTENANCE
WARNING:
When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause product damage.
WARNING:
Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury.
WARNING:
Before inspecting, cleaning or servicing the machine, shut off engine, wait for all moving parts to stop, and discon- nect spark plug wire and move it away from spark plug. Failure to follow these instructions can result in serious personal injury or property damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum- based products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury.
Only the parts shown on the parts list are intended to be repaired or replaced by the customer. All other parts should be replaced at an authorized service center.
NOZZLE MAINTENANCE
Excessive pump pressure (a pulsing sensation felt while squeezing the trigger) may be the result of a clogged or dirty nozzle.
nUnplug the pressure washer.
nTurn off the pressure washer and shut off the water supply. Pull trigger to release water pressure.
nRemove the nozzle from the spray wand. NOTE: Never point the spray wand at your face.
nUsing a straightened paper clip or nozzle cleaning tool (not provided), free any foreign materials clogging or restricting the nozzle.
nUsing a garden hose, flush debris out of nozzle by back flushing (running the water through the nozzle backwards or from the outside to the inside).
nReconnect the nozzle to the spray wand.
nTurn on the water supply.
11 — English
