'BC4050 BAGGER CART
14.Thread the dump cloth rod through the sleeve in the rear edge of the dump cloth.
Position the dump cloth with the connecting sleeve
Insertthe ends of the rod through the holes in the rear corners of the cart.
Secure each end of the rod by installinga circle clip outside the cart bed.
DUMP CLOTH
DUMPCLOTH ROD
CIRCLECUP
15.Spread out the dump cloth in the cart box, and hook the four plastic clips onto the support tube.
ASSEMBL Y
16.Install a rubber strap and hooks on the washer at the center of the cover frame rod. The open end of the lower hook must face the cart bed.
Secure the upper hook to the frame rod by closing the hook loop with pliers.
To hold the cover closed, hook the lower end to the cart bed as shown.
RUBBER ROD WASHER
Hitch Assembly
17.Install the hitch bracket on the rear of the tractor, using one 1/2 x 1 inch hex bolt, one 1M inch lock washer, one 1/2 inch nut,
four 8 x 20 mm hex bolts and four 8 mm lock washers.
Tighten the nuts and bolts securely.
HITCH BRACKET
\1/2 x 1 inch HEX BOLT
LOCK WASHER |
|
112 inch NUT / | 8x20mm |
HEX BOLT |
Page 5