Honeywell 1250G Partial Sequence, Sequence Match Beeper, Require Output Sequence, Required, On/Not Required, Discard Partial Sequence, Sequence Match Beeper Off

Sequence Match Beeper

By default, the scanner beeps when a sequence match is found. If you want the scanner to remain silent, scan the Sequence Match Beeper Off

bar code below. Default = Sequence Match Beeper On.

Sequence Match Beeper Off

* Sequence Match Beeper OnPartial Sequence

If an output sequence operation is terminated before all your output sequence criteria are met, the bar code data acquired to that point is a “partial sequence.”

Scan Discard Partial Sequence to discard partial sequences when the output sequence operation is terminated before completion.

Scan Transmit Partial Sequence to transmit partial sequences. (Any fields in the sequence where no data match occurred will be skipped in the

output.) If you have programmed a Sequence Timeout (page 3-19)and the timeout is reached, the partial sequence is transmitted. Default = Dis-

card Partial Sequence.

Transmit Partial Sequence

* Discard Partial Sequence

Require Output Sequence

When an output sequence is Required, all output data must conform to an edited sequence or the scanner will not transmit the output data to the host device. When it’s On/Not Required, the scanner will attempt to get the output data to conform to an edited sequence but, if it cannot, the scanner transmits all output data to the host device as is.

3 - 20