Setting the System — Part or Night Set
Part and Night setting are similar to Full setting but leave off certain detectors as agreed with your installer. Additionally, the system can be programmed by the installer not to give any exit timer tones during the setting period (silent set).
To Part or Night set:
Keypad:
Type your PIN code then press [B]. Press [1] Part Set or Press [2] Night Set.
Wireless Keyfob: Press the [Lower Left] button (Part) or Press the [Lower Right] button (Night).
Prox Tag:
Use the keypad for Part or Night setting.
The tag will only Full Set.
A 30 second exit timer will begin. Leave the protected area by the agreed route. A double beep at the end of the exit time will confirm setting.
PART SET | 030 |
Setting with Faults
NOTE: Display not shown when using wireless fobs to set
the system.
Normally, if there is a fault of any kind on the system, setting will not be permitted until the fault is rectified. However, depending on the
If there are faults present when you try to set via the keypad, the following typical display will be shown:
Fault Override
03 Event(s)>
Use the cursor keys to scroll through the faults. If you are able to override them, the bottom row will show the message ENT to continue>.
AC Fail
ENT to Continue
Pressing the ent key at this point will override the fault for one set period only and allow the system to set. If there is more than one fault, this process is repeated for each fault.
5