Honeywell 16 Plus manual Option 4 - Codes, Selecting the Codes option

Models: 16 16 Plus

1 30
Download 30 pages 12.7 Kb
Page 19
Image 19
Option 4 – Codes

On selecting the Walk option zone 01 is displayed. If the zone is to be tested press the # key. Use the A or B keys to scroll through the zones on the system, each one may be selected for inclusion in the test. When all the required zones have been selected press the ent key to start the Walk Test.

The keypad displays the number of Walk Test zones currently open on the system. Pressing the A or B keys allows the currently open zones to be viewed.

Walk test the selected zones by activating the appropriate sensor (movement detector, door switch, etc). When the Walk Test is complete return to the keypad. The display shows the number of test zones that are currently open. Press the # key to toggle the keypad display between showing the number of test zones currently open and the number of zones registered as tested.

To terminate the Walk Test press the esc key.

Note: If the esc key is not pressed the Walk Test remains active for 20 minutes after the last key press.

Option 4 – Codes

The Codes option enables authorised users to allocate, modify and delete the 14 user codes (PINs) on the system, as well as assign and modify user attributes. Only users with the Modify Codes attribute enabled can carry out these functions.

Selecting the Codes option

Enter your User Code and press the 4 key.

Assigning Modifying and Deleting User Codes

Once the Codes option is selected the user code assignment of User 1 is displayed. If the box next to CODE is filled then a PIN has been assigned, if it is blank then no PIN has been as-

User Number

 

 

 

 

01=USR 1 CODE

 

User Code

 

 

 

Option Selections

 

 

 

ENT, 01-14=SELECT

 

Assigned Indicator

 

 

 

 

 

 

 

 

 

 

 

 

 

signed.

Figure 3: Menu Option 4 – Codes.

Use the A or B keys to select a user number and press the ent key.

To assign or modify a user PIN enter a four digit number. Press the ¸ key to erase any digits incorrectly entered. When the required four digit code is displayed press the ent key.

If a User Code is to be deleted press the ¸ key four times followed by the ent key.

9

Page 19
Image 19
Honeywell 16 Plus manual Option 4 - Codes, Selecting the Codes option, Assigning Modifying and Deleting User Codes