If you want to set additional low priority symbologies, scan FF, then scan the 2 digit hex value from the Programming Chart for the next symbology. You can program up to 5 low priority symbologies. Scan Save to save your selection. Default =
None.
Low Priority SymbologyPreferred SymbologyOnce you have enabled Preferred Symbology and entered the high and low priority symbologies, you must set the
Scan the bar code below to set all Preferred Symbology entries to their default values.
Preferred Symbology DefaultOutput Sequence Overview
Output Sequence Editor
This programming selection allows you to program the scanner to output data (when scanning more than one symbol) in whatever order your application requires, regardless of the order in which the bar codes are scanned. Reading the Default Sequence symbol programs the scanner to the Universal values, shown below. These are the defaults. Be certain you want to delete or clear all formats before you read the Default Sequence symbol.
Note: To make Output Sequence Editor selections, you’ll need to know the code I.D., code length, and character match(es) your application requires. Use the Alphanumeric symbols (inside back cover) to read these options. You must hold the button while reading each bar code in the sequence.
To Add an Output Sequence1.Scan the Enter Sequence symbol (see Require Output Sequence, page
On the Symbology Charts on page
Specify what length (up to 9999 characters) of data output will be acceptable for this symbology. Scan the four digit data length from the Programming Chart. (Note: 50 characters is entered as 0050. 9999 is a universal number, indicating all lengths.) When calculating the length, you must count any programmed prefixes, suffixes, or formatted characters as part of the length (unless using 9999).
4.Character Match SequencesOn the ASCII Conversion Chart (Code Page 1252), page
3 - 17