Honeywell 5610/5613, 5680/5683, 5690/5693 Partial Sequence, Output Sequence Editor, Require Output Sequence, Required, Required, Enter Sequence, On/Not Required, On/Not Required, Default Sequence

FFtermination string for second code

69 code identifier for Code 93

0012 C - Code 93 sample length (11) plus CR suffix (1) = 12

43start character match for Code 93, 43h = “C”

FF termination string for third code

Output Sequence Editor

Enter SequenceDefault SequencePartial Sequence

If an output sequence operation is terminated before all your output sequence criteria are met, the bar code data acquired to that point is a “partial sequence.”

Scan Discard Partial Sequence to discard partial sequences when the output sequence operation is terminated before completion. Scan Transmit Partial Sequence to transmit partial sequences. (Any fields in the sequence where no data

match occurred will be skipped in the output.)

Transmit Partial Sequence

* Discard Partial SequenceRequire Output Sequence

When an output sequence is Required, all output data must conform to an edited sequence or the scan engine will not transmit the output data to the host device. When it’s On/Not Required, the scan engine will attempt to get the output data to conform to an edited sequence but, if it cannot, the scan engine transmits all output data to the host device as is.

When the output sequence is Off, the bar code data is output to the host as the scan engine decodes it. Default = Off.

Note: This selection is unavailable when the Multiple Symbols Selection is turned on.

Required

On/Not Required

3 - 15