Honeywell 5610/5613, 5680/5683, 5690/5693 Single Scan Data Format Change, Data Format Non-MatchError Tone, Error, Tone On, Non-Match, Non-Match, Data Format, Data Format, Data Format, Data Format

Data Format Non-Match Error Tone

When a bar code is encountered that doesn’t match your required data format, the scan engine normally generates an error tone. However, you may want to continue scanning bar codes without hearing the error tone. If you scan the Data Format Non-Match Error Tone Off bar code, data that doesn’t conform to your data format is not transmitted, and no error tone will sound. If you wish to hear the error tone when a non-matching bar code is found, scan the Data Format Non-Match Error

Tone On bar code. Default = Data Format Non-Match Error Tone On.

*Data Format Non-Match Error Tone OnData Format Non-Match

Error Tone Off

Primary/Alternate Data Formats

You can save up to four data formats, and switch between these formats. Your primary data format is saved under 0. Your other

three formats are saved under 1, 2, and 3. To set your device to use one of these formats, scan one of the bar codes below.

Primary Data Format

Data Format 1

Data Format 2

Data Format 3

Single Scan Data Format Change

You can also switch between data formats for a single scan. The next bar code is scanned using an alternate data format, then reverts to the format you have selected above (either Primary, 1, 2, or 3).

5 - 13