If the File is Not an Installer

Some programs cannot be installed on workstations because they are designed exclusively for Windows CE devices. In these cases, the appropriate files must be stored on the host workstation and transferred to the terminal via ActiveSync Explore.

Note: If an error message stating that the program is valid but designed for a different type of computer appears when you try to install the program on the workstation, the program is not an installer.

1.If you cannot find any installation instructions for the program in the Read Me file or documentation, open ActiveSync on the workstation and click Explore.

2.On the workstation, navigate to the workstation folder containing the program file(s) and copy them to the Program Files folder on the terminal.

If you want the program to persist through hard resets, save the program to the Autoinstall folder (\Honeywell\AutoInstall).

3.On the terminal Desktop, tap My Device and, in Windows Explorer, navigate to the folder where the program is located.

4.Double tap on the program file to install it.

If you copied the file to the Autoinstall folder, you can choose to install the program by performing a hard reset. The program installs as part of initialization.

5.After installation is complete, access the program by tapping Start -> Programs, and the program appears on the Programs screen. Tap the icon to open the program.

Wireless RadiosThere are two radio options: 802.11b/g and Bluetooth.1.802.11b/g (WPAN/WLAN configuration): see WLAN (802.11b/g Radio), below.2.Bluetooth (WPAN configuration): see Bluetooth Handler on page 8-1.Connecting the Terminal to a Wireless Network

You connect the terminal to a wireless network through the on-board radio (802.11b/g and/or Bluetooth). Each radio has its own configuration program and requires specific information about the wireless network to connect. Successful connection depends on your network infrastructure about which you will need specific information from your network administrator.

WLAN (802.11b/g Radio)

Dolphin 6100s can have a 2.4 GHz 802.11b/g WLAN (Wireless Local Area Network) radio that uses Direct Sequence Spread Spectrum (DSSS) technology. The radio is interoperable with other 802.11b/g, Wi-Fi- compliant products including access points (APs), workstations via PC card adapters, and other wireless portable devices.

By default, the 802.11b/g radio is powered-off (i.e., disabled) “out of the box” To power it on (i.e., enable), press the vertical arrow (bottom right corner of screen) and select Turn Wireless LAN On. The enable/ disable state of the radio will survive subsequent soft and hard resets. The next step is to configure the connection parameters of the radio to connect to a wireless network.

Configuring the WLAN Radio

The WLAN radio is configured in the Honeywell WLAN Security Supplicant, which you access by double tapping the program icon in the command bar.

7 - 6