!We recommend use of Honeywell peripherals, power cables, and power adapters that comply with L.P.S. Use of any non-Honeywell peripherals, cables, or power adapters may cause damage not covered by the warranty.

Connecting Power to the ChargeBase

Power

Adapter

A/C Power Cord

Power Connector Cable

1.Plug the A/C power cord into the power adapter.

2.Plug the power connector cable into the power connector on the back of the ChargeBase.

3.Plug the A/C power cord into a standard wall outlet.4.The base is ready to begin charging terminals.Charging the Battery

The base provides power to the Dolphin terminals and allows the charging of the batteries in the terminals. The battery of each terminal charges in 6 hours for the standard 3.7V battery or 9 hours for the extended 3.7V battery. The intelligent battery charging system incorporated into all Dolphin terminals prevents overcharging, which means that Dolphin terminals may be stored in the base indefinitely without damage to the terminals, battery packs, or the base.

To Power a Terminal and Charge its Battery

1.Install the battery pack in the terminal; see Install the Main Battery on page 2-1.

2.Verify the base has power. If the LEDs are not illuminated, see Connecting Power to the ChargeBase on page 10-3.

3.Slide the Dolphin terminal into one of the four terminal wells. The the Power/Dock LED for the well changes to green. Charging begins immediately if required by the Dolphin terminal.

!Make sure the terminal is dry before placing it in the ChargeBase. Do NOT place a wet terminal in the ChargeBase! Doing so may cause damage not covered by the warranty.

!We recommend use of Honeywell Li-Ion battery packs. Use of any non-Honeywell battery may result in dam- age not covered by the warranty.

10 - 3