Honeywell 99EX, 99GX Installing a Memory Card, 4.Wait at least 3 seconds, then remove the battery

Installing a Memory Card

Note: Format all microSD/SDHC cards before initial use.

1.Press the Power key to put the terminal in Suspend Mode.

2.Release the hand strap hook near the speaker on the back panel of the terminal (99EX models only).

3.Remove the battery door.

4.Wait at least 3 seconds, then remove the battery.

5.Remove the T6 TORX screw securing the protective door closed.

6.Lift up the lower left corner of the door to access the memory socket.

7.Unlock the access door to the socket by sliding the door toward the IrDA port side of the terminal.

8.Lift the door to expose the socket.

9.Slide the microSD or microSDHC card into the door of the socket.

Note: Make sure the interface on the memory card is connected to the interface in the socket; align the notch on the card with the notch of the socket.

Step 5

Step 6

Step 7

Step 8

Step 9

17