Honeywell EKZ008200B user manual Duress Code, Iincorrect Code Protection, Personal Attack

DURESS CODE

A duress code can be used if you are forced to disarm your security system

Nunder duress. Your duress code is +1 to your code (1234 => 1235, 6789 => 6780).

GThe system will disarm as normal however a silent alert signal is transmitted to

Code + 1

L

your Alarm Receiving Centre.

IINCORRECT CODE PROTECTION

SIf you enter 5 successive wrong codes, the keypad is blocked for 5 minutes.

H

PERSONAL ATTACK

You can send an instant personal attack alarm whenever you feel threatened whilst at home, even when your system is not armed :

Press the “SOS” keys simultaneously

￿The siren is triggered (depending on configuration).

￿The Alarm Receiving Centre is alerted.

PROGRAMMING YOUR KEYPAD

The keypad can have up to 10 users. User 1 has the master code or master TAG.

To enter programming :

•Press “on” and “off” control keys simultaneously.

￿The red light will flash slowly.

•Enter the master code or present the master TAG.

To change or set additional user codes :

•Select and enter an existing or new single digit user ID (0-9).

•Enter the new code for this user.

￿A double beep on the keypad will confirm entry.

•Enter the new code again to confirm it.

￿A double beep on the keypad will confirm entry.

To change or set additional key tags :

•Select and enter an existing or new single digit user ID (0-9) (User 1 is always the master).

•Present the new key TAG.

￿A double beep on the keypad will confirm that the new TAG is programmed and replace the previous TAG if any.

+

- 10 -