7- How to control your system over the phone
Control of your system over the phone is only possible from a
The Domonial control panel picks up your call after the number of rings configured by the installer or after it has been called twice successively.
To access your system:
•Dial the phone number of your security system .
A
•Enter a valid code within 30 seconds.
A
To arm your system:
•Dial * 21 to arm the total set, *22 to arm the part set, * 23 to arm the annex set.
Arming is confirmed as soon as you can hear a melody.
To disarm your system*:
• Dial * 31 to disarm the total set, *32 to disarm the part set, *33 to disarm the annex set.
To control an electrical device**:
•Dial *101 to *112 based on the number of the equipment programmed in your alarm system.
One short beep informs you that your equipment is active .
Two beeps inform you that your equipment is not active.
•Dial 1 to turn on the device, 0 to turn it off.
To listen to the site and talk through the microphone of the control panel (if configured):
•Dial *6 to enter
•Dial 1 to talk, and 0 to listen again.
To terminate the call:
•Dial * then #.
Your security system ends the call.
Access your system | Call system + Enter CODE |
|
|
Total set arming | *21 |
|
|
Part set arming | *22 |
|
|
Annex set arming | *23 |
|
|
Control equipment | *101 - *112 | 1: ON | 0: OFF |
Audio verification | *6 | 1: TALK | 0: LISTEN |
Terminate the call | *# |
|
|
*This function is not available on all product versions and depends on country regulations. ** This function requires an optional X10 extension with X10 modules.
E
N G L I S H
- 15 -