Setting with Faults
Normally, if there is a fault of any kind on the system, setting will not be permitted until the fault is rectified. However, depending on the
If there are faults present when you try to set via the keypad, the following typical display will be shown:
Fault Override
03 Event(s)>
Use the cursor keys to scroll through the faults. If you are able to override them, the bottom row will show the message ENT to continue>.
AC Fail
ENT to Continue
Pressing the ent key at this point will override the fault for one set period only and allow the system to set. If there is more than one fault, this process is repeated for each fault.
Cancelling System Setting
The Full, Part and Night setting routines can be cancelled, before the system sets, by pressing the esc key on the keypad used to begin the setting routine. To cancel the setting routine on another keypad, type in your user PIN code and press A> or ent.
Unsetting
To unset the system, enter the protected area by the agreed route. A timed entry period will begin and a pulsed tone will sound.
Keypad: | 5804 Keyfob : | KTC805 Keyfob : | Prox Tag: |
Type your user code | Press the [OFF] button. | Press button 2. | Hold the tag in front |
then press [ent]*. |
|
| of the prox symbol. |
|
|
|
* NOTE: Unsetting using a keypad may not be possible on DD243 compliant systems.
6