Honeywell HMLCD19 user manual Controls Rear Panel, Installing the Monitor Driver, VGA Cable

2.2CONTROLS – REAR PANEL

A B	C	D	E
			F

G

DVR or VCR

PC

ADC12V

BEar

CPC Sound

DVGA

EVideo Sound

F S-VHS AV1

GComposite

Rev. A	6	HMMU000882
		04/09/04

2.3INSTALLING THE MONITOR DRIVER

You can achieve an optimal resolution and scanning rate by installing the monitor driver as follows:

1.Insert the monitor driver diskette into the floppy diskette drive and run INSTALL.EXE.

2.Select the monitor model then press OK. The installation will begin immediately.

2.4VGA CABLE

A 15-pin D-Sub connector is used as the input signal connector. Pin and input signal are shown in the table below.

Pin	Name	Pin	Name	Pin	Name
1	Red	2	Green	3	Blue
4	N.C	5	GND	6	RED-GND
7	GREEN-GND	8	BLUE-GND	9	+5V
10	Logic-GND	11	N.C	12	SDA (DDC)
13	H-sync	14	V-sync	15	SCL (DDC)

Rev. A	7	HMMU000882
		04/09/04