Honeywell IPGSM-4GC manual Dialer Capture Module Information, LED Display Information

IPGSM-4GC Commercial Fire Communicator – Installation and Setup Guide

Dialer Capture Module Information

LED Indicator	STATUS
RED – Steady ON	Messages exist in buffer.
RED – Flashing	No messages to be sent. Waiting for messages.
GREEN – Steady ON	Normal Indication.
GREEN – Blinks every 2 sec.	PowerBoost1 communication problem.
GREEN – Blinks twice every sec.	Connection with the Communicator is lost.
GREEN – Blinks 10 times every sec.	PowerBoost1 and Communicator connections are lost.

2Tip		ECP	EOL EOL	ZN+ RWP GND 1Tip 1Ring			uODatat InData In12V GND
	Ring2 ZN-
			1
			Telco					RED
			2
						GREEN
			Telco		Dialer Capture Module

iPGSM-COM-004-V0

Note: Telco ports 1 (primary dialer) and 2 (secondary dialer) may be used instead of the terminal board.

Whichever connection method is used, both Telco paths must be connected to the Fire Panel.

LED Display Information

Status	LED Indicator
RADIO TROUBLE	Yellow – ON when radio trouble is present.	RADIO TROUBLE
	∙ Both IP and GSM communication paths are lost.
	∙ Communicator radio is not registered.	zzer
	∙ Old Alarm Time has been exceeded. (Message has not been
	delivered within the fixed 10 minute window.)	u
		b
	Buzzer – Upon loss of AC power, this will beep once every 10
		LOW BATTERY
	seconds.
		(not used)
LOW BATTERY	Yellow – ON when battery is low (<11.5VDC).
		AC LOSS
	Yellow – (not used)
		AC ON
AC LOSS	Yellow – ON when no AC is present (< 90VAC).
AC ON	Green – ON when AC is present.

Note: If a wire pulled out of the LED Board Connector refer to the diagram on right and reinsert wire, ensuring the connector pin is locked in.

Violet		LED Board
Black
		Connector
White
	NC	Wires
Red
	NC
Brown
Yellow
Gray

– 9 –