Bendix/King | Honeywell KMA28 instruction

Installation and Operation Manual

BENDIX/KING®

KMA 28

FAA-Approved TSO C50c, C35d

JAA-Approved JTSO-2C35d, C50c

Audio Amplifier /Intercom/

Marker Beacon Receiver

Document P/N 006-10565-0000

REVISION 0, SEPTEMBER 2000

WARNING

Prior to export of this document, review for export license requirement is needed.

Honeywell International, Inc. 2000©

Copyright Notice

Reproduction of this publication, or any portion thereof, by any means without the express written permission of Honeywell International, Inc. is prohibited. For further information contact the Manager, Technical Publications; Honeywell Business & General Aviation, Olathe, Kansas 66061. Phone (913) 782-0400.

Image 1

Honeywell KMA28 operation manual Bendix/King

Contents

BENDIX/KING Table of Contents Cellular Interface Checkout Introduction Section I General InformationScope Equipment Description TSO Approval Approval Basis TSO Compliance Specifications Equipment Supplied Intercom Specifications License Requirements Equipment Required but not Supplied Equipment Installation Procedures Section II InstallationGeneral Information Unpacking and Preliminary Inspection Connector Assembly Mounting Rack InstallationCable Harness Wiring Noise Existing PS Engineering PMA6000 installations Existing KMA-24 InstallationPower Communications Push-to-Talk Unswitched inputs Swap ModeIntercom wiring Backlighting Public Address function Com 3 Audio Marker Installation Communications Antenna Installation Notes AdjustmentsWireless telecommunications interface Hook Switches KMA 28 Pin Assignments Unit Installation Post Installation CheckoutOperational Checkout Receiver Sensitivity Marker CheckoutCellular Interface Checkout Final Inspection Audio Selector Section III KMA28 OperationKey click Speaker Amplifier Public Address PA Function Power Switch /Emergency EMG OperationMicrophone Selector Split Mode Swap Mode Switch from Com 1 to Com 2 remotelySplit Mode ICS Telephone Mode IntelliVox VOX-Squelch Intercom System Mono headsets in Stereo Installation Volume ControlIntercom Modes Soft Mute and Soft Mute inhibit Telephone Operation if equipped with approved system Marker Beacon Operation Will lose intercom capability when it is in use Appendix a Installation Drawings Connector viewed from the rear Tray Dimensions in inches Top View Tray Assembly Drawing Bottom Connector, J1 Appendix B Bottom Connector Interconnect J2 TOP Connector Appendix C Top Connector Interconnect Instructions for FAA Form Instructions for Continuing Airworthiness Conditions Section Conducted Tests