Honeywell KMA28 operation manual Approval Basis, TSO Approval

Models: KMA28

1 35
Download 35 pages 20.6 Kb
Page 5
Image 5
1.4APPROVAL BASIS -

Bendix/King

KMA28

Audio Amplifier/Intercom/Marker Beacon Receiver

A six-station voice activated (VOX) intercom is included in the KMA 28. This system has the advanced IntelliVox® circuitry that eliminates manual adjustments. The system contains six separate VOX mic circuits, and only opens the microphone channel in use.

The intercom system incorporates pilot isolate and crew modes, two stereo (or mono de- pending on unit) music inputs with "Soft Mute," and LED indicators for swap and trans- mit indications. Intercom control is through front panel-mounted knob and 3 position mode switch. A single volume controls intercom level for the pilot and copilot. Passenger headphone volume is factory set, and adjusted in flight with headset-mounted volume controls. Passenger volume control is further adjustable through screwdriver access in the top of the unit. Intercom squelch is automatic.

A 3-light Marker Beacon receiver is integrated in the KMA 28. This provides the neces- sary Marker Beacon lights and audio indications necessary for an Instrument Landing System (ILS) approach.

1.4APPROVAL BASIS -

TSO Approval.

The KMA 28 Audio Selector Panel is FAA approved under TSO C50c (Audio Amplifi- ers) and TSO C35d (Marker Beacon Receivers). In addition, they are approved by the Joint Airworthiness Authorities under JTSO C50C and JAR-TSO 2C35d. The TSO holder and manufacturer is PS Engineering, Incorporated, Lenoir City Tenn., USA.

The KMA28 complies with relevant portions of EUROCAE RTCA MPS WG No. 7/70, DO-143 and (Marker Beacon Receivers), ED-14C/DO-160C (Environmental Conditions and Test Procedures for Airborne Equipment), ED12B/DO-178B (Software Considera- tions for Airborne Equipment) and ED- 18/DO-214 (Audio Systems Characteristics and Minimum Operational Performance Standards for Aircraft Audio Systems).

Operation is subject to the following conditions: This device may not cause harmful interference.

This device must accept any interference received, including interference that may cause undesired operation.

006-10565-0000

Page 1-2

Rev. 0, Sept. 2000

Page 5
Image 5
Honeywell KMA28 operation manual Approval Basis, TSO Approval