Honeywell ST 3000 manual 92

A.8 Typical Smart Meter Indications, Continued

Operation error codes,

continued

Table A-11 Smart Meter Error Codes and Descriptions, continued.

If error indication is . . . Then, it means

You have tried to set a span value that is outside acceptable limits for your transmitter.

VAR	UPPER
SEL.	VALUE

0 % 100

E r 4		UNITS
	%	S E T
ANALOG		LOWER
		VALUE

					You have tried to invoke a smart meter set function with
					the transmitter’s Write Protect jumper in its Read Only
SEL.				VALUE	position. You cannot make changes in the smart meter
VAR		%	100	UPPER	settings when the transmitter’s configuration is write
0				UNITS
	E r 5				protected.
			%	S E T
		ANALOG		LOWER
				VALUE

Meter/transmitter	• Cycling transmitter power OFF/ON will have no affect on meter
interaction	configuration. The meter digital readout will be in the previously set
	engineering units and applicable upper and lower display limits will
	be intact when transmitter power is restored. (See	ATTENTION	in
	Subsection A.4 when setting range values and configuring the meter
	display.)
	• If you switch the transmitter mode from Analog to DE, the
	ANALOG indicator on the meter will go out. If you switch from DE
	to Analog mode, the ANALOG indicator will light.
	• If you reconfigure the transmitter output conformity from SQUARE
	ROOT to LINEAR, the meter’s digital readout will automatically
	revert to the default engineering unit of percent and the FLOW
	indicator will go out when the change is downloaded to the
	transmitter. Likewise, if you reconfigure the transmitter output
	conformity from LINEAR to SQUARE ROOT, the meter’s digital
	readout will automatically revert to the default engineering unit of
	percent and the FLOW indicator will light when the change is
	downloaded to the transmitter. In either case, you must reconfigure
	the transmitter as outlined in Subsections A.5 or A.6 of this manual.

82 ST 3000 Release 300 Installation Guide 2/05