T8775A,C THE DIGITAL ROUND™
INSTALLATION
NO
YES
NO
NO
5FEET
[1.5 METERS]
M19716A
Fig. 2. Typical thermostat location.
Separate Wallplate from Thermostat
1.Place your thumbs on top of the thermostat and wall- plate. Use your thumbs to pull the thermostat away from the wallplate. See Fig. 3.
TOP OF | WALL PLATE |
THERMOSTAT |
|
Mount wallplate to wall (See Fig. 4) as follows:
WALL ANCHORS (2)
WALL PLATE
1
M19679 | WIRING HOLE |
|
|
| |
| 1 INCH SCREW (2) | M19499 |
Fig. 3. Separate wallplate from thermostat.
1WHEN USING WALL ANCHORS, DRILL 3/16 IN. HOLES FOR DRYWALL, 7/32 IN. HOLES FOR PLASTER.
Mount Wallplate to Wall
NOTE: Level wallplate for appearance only. The thermostat functions normally even when not mounted level.
Fig. 4. Mount wallplate to wall.
1.Pull the thermostat wires through the wiring hole on the wallplate.
2.Use a pencil to mark the center of the screw holes on the left and right sides of the wallplate.
3.Remove the wallplate from the wall and drill two 3/16 in. (5 mm) holes in the wall (if drywall) at the locations you marked. For materials such as plaster, drill 7/32 in.
(6 mm) holes where marked.
3 |
