•Avoid using rechargeable batteries. (Rechargeable batteries cannot maintain correct power requirements).
•Insert batteries before first use, matching the polarity in the battery compartment
•During an initial setup, place the main unit close to the remote UV sensor.
•After reception is established (the remote UV readings will appear on the main unit’s display), position the UV sensor and the main unit within the effective transmission range of 328 feet (100 meters). Ideally it should be placed within the line of sight of the main unit.
•Transmission range may be affected by trees, metal structures and electronic appliances.
•The effective operating range may be influenced by the surrounding building materials and how the receiver (main unit) and transmitter (UV sensor) are positioned.
•Place the remote UV sensor so that it faces the main unit (receiver), minimizing obstructions such as doors, walls and furniture.
Installation
The Honeywell Remote UV sensor TS704 operates at 433MHz radio frequency, so no wire installation is required between the main unit (receiver) and the remote UV sensor (transmitter).
All data measured by the remote UV sensor is transmitted to the main unit wirelessly, with the operating range of 328 feet (100 meters) in the open area.
Remote UV sensor must be placed outdoors to measure ultraviolet light levels. To install it:
•Unscrew the lid on top of the UV sensor unit.
•Remove the screw from the battery compartment door with a small Phillips screwdriver.
•Insert two 2 “AA” size 1.5V batteries (not included) matching the polarities shown in the battery compartment.
•Replace the battery compartment door and secure the screw. The red light from the LED indicator will flash once meaning the UV sensor works properly.
•Screw the UV sensor unit lid back.
•Press DOWN button either on the main unit control panel or handheld remote control. The UV reading (usually 0.00) will appear in UV window of TE923W main unit display, instead of “ - -
Assembly
•Snap the
•Insert the round end of the
5
