Press | both | latches | (B) | and | pull | brush | To | replace |
| brushes |
| Press brush | firmly | to snap | into place. | ||
block | out, The brushes | can | be | cleaned |
|
|
|
|
|
|
|
|
|
|
| ||
under | running | water. |
|
|
|
| Align | posts | (C) | on | both | ends | of | brush |
|
|
|
|
|
|
| assembly | with | slots | (D) | in cleaner | hous- |
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
ing,
Make sure that the square post (E) also
aligns _'ith the square hole (F), Turn
brushes slightly until post fits easily into hole,
Storage
aefort_" | storing | : |
|
|
|
|
|
|
| |
• |
| solution | tank | and | rqnse |
|
| |||
| thoroughly |
| with | clean |
| water. |
|
| ||
• | Roplac@ | empty | so;ution |
| tank | and | ||||
| turn | deep | cleaner | ON, | Squeeze |
|
| |||
| trigg_.'r | and | push | deep |
| clean_'r |
| for- | ||
| ward | and | back | several |
|
| times | to |
| |
| exp_;I |
| any | solution | remaining | in | the | |||
| deep | cleaner's | system, |
|
| (Do not | use | |||
| deep | cleaner | on | wood |
| floors,) |
|
| ||
• | Empty |
| recovery | tank |
| and | rinse |
|
| |
| thoroughly |
| with | clean |
| water, |
|
|
Allow brushes and underside of deep
cleaner to air dry thoroughly before storing deep cleaner on a carpeted or wood surface.
Do not store deep cleaner with a full solution tank in place.
Lubrication
The | motor | is | (_'quipped |
| with | boarings | ||
which |
| contain | sufficient |
| lubrication | for | ||
the | life | of | the | motor. | The | addition | of | |
lubricant |
| could | cause | damage, |
| Do not |
add lubricant to motor bearings.
14
If a | mlllor | problem | occurs, | it | usually | can | |
be | solved | quite | easily | when |
| the cause | is |
found | by | using | the check |
| list | bE;low, |
|
I-j?._'I[eJfIL'rjB'T"dlq
Possible cause
Possible solution
•Not firmly plugged in
•Plug unit i;q firmly
•No voltage in wall plug
•Check fuse or breaker
•Blown fuse/tripped breaker
" Replace fuse/reset breaker
Possible cause
Possible solution
•Recovery tank full/automatic
shut off engaged
• Removo and ompty recovery tank
•Blockage in tool on end of hose
e Remove tool _nd
-Recovery tank lid not on correctly
• Make sure lid is on securely
Possible cause
Possible solution
•Solution tank not firmly in place
•Make sure tank is securely locked im
position
•Solution tank empty
e Refill t_nk according to Instructions for
surface being clef]ned
•Recovery tank lid not on
correctly
• Make sure lid is firmly in place
•Pump needs to be "primed"(when using tool)
•See "Before using tool" section, p,11
Possible cause
Possible solution
•Dirty filter screen on bottom of unit
• Cloan scr_;_.rl as sbown in Fig.
•Speed selector on OFF
•Mows,