The assembled | cleaner | wi+l took | like this |
drawing (LS modet shown),
Assemblehandle
m
AI
A2
i
Attach upper handle
Remove clean solution tank (upper tank)
from de_;p
W+thhose hook (A1) and cord hook (A2) to
back of deep cleaner, push upper handle
down onto lower handle, Push bOllS into
ho+s on front of handle. If bolts will not go through hole easily handle is not
pushed completely down,
)/
/
Attach hose holder
Position hose holder (B) onto handle by
matching tabs on rack with op[_nings on
back of handle, Make sure holes for
bolts are aligned,
Replace | clean | solution | tank | (upper | tank) |
by positioning | bottom | first, | Press | on |
tank handle to snap top of tank into
place.
4
Place | nuts | in | recessed | areas | on |
| back of | ||
handle, | Hold | each | nut | in | place |
| while | ||
tightening | each | bolt | securely |
| (from | the | |||
front | of the brindle) | with | a | Phillips |
| screw | |||
driver, |
|
|
|
|
|
|
|
|
|
Only | two | nuts | are | needed |
| on | this |
| model, |
The | extra | nut | is not | required |
| but |
| has | |
beelq | provide_ | for | your | convenience, |
|
|
Attach tool holder
Remove tool and taped screw from holder.
Insert projections on holder into slots on
b_k of cleaner,
When handle sections are completely together, squeeze trigger (C) and depress Clean Surge TM Button* (D) on upper handle.
You will hear a "snap"when the trig- ger rod is in place.
+some models
Slide | rack | down | into | place, | insert | screw |
at (E) | and | tight_;n | with | a Phillips | screw- | |
driver, |
|
|
|
|
|
|