Before _you begin
cleaning
a. Vacuum thoroughly - For carpet, use
a HOOVER | vacuum | cleaner- |
| with | an | agi- | ||
tator | for | best | results. | Vacuum |
| upholstery |
| |
with | a vacuum | cleaner | with | cleaning |
|
| ||
tool | attachments. | Use | a crevice | tool | to | |||
reach | into tufts | and folds, | Do not | use |
|
the 'SteamVac'deep cleaner as a dry vacuum cleaner.
b. For upholstery, check cleaning code - Use your HOOVER 'StearnVac'
'Widepath' deep cleaner only If the
upholstery fabric is marked with a "W"
(for "wet" cle_n) or "StW" (for
"solvent/dry" or "wot" clean), Do not
clean fabric marked "S" ("solvent/dry"
clean only), Ir your uphoLsto.ry do[;s not
have | a code, | seek | professional | assis- |
tance,
c,Test for colorfastness - Mix detergent
_lld Water _ccording to the Instructions
After |
|
| cleaning |
|
| ||
a, Allow | carpet | or | upholstery | to | dry, To | ||
help | prevent |
| matting | alqd | resoiling | the | |
carpet, |
| keep |
| children | arid | pets | away |
frol_q | surface |
| until | it is completely | dry. If |
it is necessary to walk on damp car-
pet, place towels or white cloths on the
traffic _lrea s,
If furniture must be replaced before the
carpot is dry, place plastic or aluminum
foil under legs of furniture so metal
slid_;s or wood finish_;s will not stair] thl _. carpet,
under "Fill cJean solution tank", Figs.
solution, In a Sl_lall, hidden area, gently rub
the surface with the dampened cloth, Wait
ten rn[nutes and check for color relTiOVal or
bleed with wh_e paper towel or cloth, If sup
f_:_ce has more than one color, check all COl- ors,
d.When cleaning entire floor, move furniture out of area to be cleaned
(may |
| not | be | necessary | if only | high | traffic | |
areas |
| are | to | be cleaned), | For | furniture | ||
too | heavy | to | move, | place | aluminum | foil | ||
or wax | paper | under | legs, | This | will | ple ~ | ||
vent | wood | finishes | from | staining | carpet. | |||
Pin | up | furniture | skirts | and | draperies. |
|
e. Pretreat spots and heavy traffic areas with HOOVER® PreCleaner*-
Test | PreQk;an_;r |
| for |
|
| by | [ir_,t | |||||||
spraying | it | on | a | hidden |
| area; | Wait | ten |
| |||||
minutes | and | blot |
| with | white | paper |
| towels | ||||||
or | cloth. |
|
|
|
|
|
|
|
|
|
|
|
| |
If | no color | change |
| is visible, |
| spray |
|
|
| |||||
ProOleaner |
| onto | spots | and | _'affic | areas, |
| |||||||
Wait | at least | ten | minutes. |
| Use | your |
|
|
| |||||
*SteamVac' |
| 'Widepath' | deep | cleaner |
| to | pick | |||||||
up |
| PreOleaner |
| and | spot, | Repeat | until | spot | ||||||
is | remov[:d; |
| cart_fully | scrub | with | a | Iqouse- |
| ||||||
hold | scrub |
| brush | if | necessary, |
|
|
|
|
| ||||
b. If | desired, |
| the | carpet |
| may | be | rinsed |
|
Rinsing is not necessary for cleaning,
but It may improve the surface's appear-
ante after it is dry.
If rinsing Is desired, be careful not to
Allow time for carpet or upholstery to dry completely between cleaning and
rinsing. To rinse, follow the same proce-
dure for cleaning only using hot tap
water with no detergent in the upper
clean solution tank.
C. Empty tanks, rinse with clear water
and let air dry, Rinse the solution tank
cap and recovery tank lid and let air dry.
Do not saturate carpet or upholstery with
PreCleaner,
If you do not have access to the
PreCleaner Spray, double the amount of HOOVER Detergent (use 2 capfuls
or 10 oz. per I gallon) in the clean solution tank,
No cleaning sorution
all carpets. Stain removal varies with the
type of spill, time elaps[_d before removal,
carpet material, and carpet type,
f.To prevent staining, use plastic or alu-
minum foil to plotr.'¢_ wood or metal sup
faces from possible water spray,
g.To avoid wetting and possible damage to wood fleers underneath area rugs/car-
pet, either move area rugs/ carpet to a non-
wood bare floor surface or place wat(;rptcx3f
material (eg, plastic) underneath them
before cleaning,
*Available at additional cost if not included with your model,
See pages
cleaning tasks,
!
d. Remove lint from filter screen rotated
inside recovery tank,
e. Remove lint from filter screein located
on bottom of cleanser as follows. Note:
When brushes seem to be rotating
slowly, disconnect deep cleaner from electical outlet and check and clean
this screen.
Tilt | cle[_ner | back | so | handle | rests | on | floor, | |
Squeeze | frame, | lift | and | pull | it out. |
| Wipe | |
off | screen | and | push | frame |
| back | into |
|
place. |
|
|
|
|
|
|
|
Return cler]n[;r to upright position.
f. If desired, vacuum thoroughly after
carpet has completely dried, This will
help reduce any shadi;qg left by the
deep cleaner's brushes,
To clean nozzle
Iflint or oth_'r d_;bris becomes lodged in
nozzle, do not attempt to remove
nozzle cover.
Pour ono to two cups of clear water on a
onto a wood floor.
Pick up the water with your deep clean-
er, Repeat as necessary until debris is
flushed out of nozzle.
Some models have a nozzle clean-out
tool for removilqg debris or if a
peted | floor | is not available. | To use the |
tool:
Disconnect deep cleaner from electri- cal outlet.
Slide tool into nozzte and remove debris
a_ %hown,
Continued "_ 9