Changing a running programme
Proceed as follows to change or cancel a running program:
■Hold the "RESET" button down for at least 5 seconds.
The programme indicator lights will flash and some audible signals will sound.
■The running programme will be cancelled.
■At this point a new programme can be set.
WARNING!
Before starting a new programme, you should check that there is still detergent in the dispenser.
If necessary, top up the dispenser.
Programme operations
When a programme is running the relevant indicator light will remain on and the 3 “PROGRAMME STATUS” indicator lights ("WASH" , "DRY" , and "END" ) will light singularly and in sequence to indicate the current phase.
If there is any break in the power supply while the dishwasher is operating, a special memory stores the selected programme and, when the power is restored, it continues where it left off.
Programme end
A 5 second alarm will sound (if not muted) 3 times at 30 second intervals to signal that the programme has ended.
The programme end indicator light will turn on, while all the others indicator lights will turn off.
Dishes can now be removed and the dishwasher turned off by pressing the "ON/OFF" button or dishes can be loaded for new cycle
Option buttons
"SUPER ECO" button
This button provides an energy and time saving of 25% on average (according to the select cycle) reducing the wash water temperature and the drying time during the final rinse.
This programme is recommended for light soil washes, and for slightly wet dishes that are not fully dry, & improved drying results. We advise you to leave the door of the Dishwasher
"ALL in 1" button
This option optimises the use of "ALL in 1" ("3 in 1"/"4 in 1"/"5 in 1", ecc.) combined detergents.
By pressing this button, the selected washing programme is modified to get best performance from combined detergents (furthermore, the salt aid shortage light is
WARNING!
Once selected, this option keeps being on (light on) also for next washing cycles and it can be
IMPORTANT
When this option is selected, the "RAPID" cycle is 10 minutes longer.
"DELAY START" button
The dishwasher start time can be set with this button, delaying the start by 3, 6 or 9 hours.
Proceed as follows to set a delayed start:
■Press the "DELAY START" button (each time the button is pressed the start will be delayed by 3, 6 or 9 hours respectively and the corresponding time indicator light will illuminate).
■To start the countdown, press the "START" button (the selected programme indicator light will come on, while the set time indicator light will start to flash).
22