Water connection
IMPORTANT
The appliance must be connected to the water mains using new
■The inlet and drain hoses can be directed to left or right.
IMPORTANT
The dishwasher can be connected to either cold or hot water, as long as it is no hotter than 60 °C.
■Water pressure must be between 80 kPa and 800 kPa. If the pressure is below the minimum consult our service department for advice.
■The inlet hose must be connected to a tap so that the water supply can be cut off when the machine is not in use
(fig. 1 B).
■The dishwasher is fitted with 3/4" threaded connector (fig. 2).
■Connect inlet hose “A” to water tap “B” with a 3/4" attachment making sure that it has been properly tightened.
■If it is necessary, the inlet pipe can be lengthened up to 2,5 m. The extension pipe is available from the After Sales Service Centre.
■If limescale deposits or sand are present in the water, it is advisable to obtain the appropriate filter, art. 9226085, from the After Sales Service Centre (fig. 3). The filter “D” must be inserted between the tap “B” and the inlet hose “A”, remembering to fit the washer “C”.
■If the dishwasher is connected to new pipes or to pipes which have not been in use for a long time run water through for a few minutes before connecting the inlet hose. In this way no deposits of sand or rust will clog up the water inflow filter.
1
2
3
5
