Cleaning tools
Tools allow for cleaning surfaces above the floor and for reaching hard to clean areas.
The cleaner is ready for tool use when handle is in upright position.
CAUTION: The agitator continues to rotate while cleaner handle is in upright position. Avoid tipping cleaner or setting it on furniture, fringed area rugs or carpeted stairs during tool use.
How to clean tools
To clean the hose and powered hand tool, wipe off dirt with a cloth dampened in a mild detergent. Rinse with a damp cloth. DO NOT submerge powered hand tool in water.
Cleaning tools may be washed in warm water with a detergent. Rinse and air dry before using.
|
B |
A |
Removing hose
When using cleaning tools, cleaner handle should be in the upright position. Also, turn cleaner OFF before disconnecting and con- necting hose to hose tube (A).
To use hose, lift hose end (B) as shown.
When you are finished cleaning with the tools, reposition hose end onto tube.
2-12
C
D
E
Select proper tool
C. Combination tool use with brush attached for carved furniture, table tops, books, lamps, lighting fixtures, venetian blinds, base- boards, shutters, and registers. Remove brush to clean upholstered furniture, draperies, mattresses, clothing, and carpeted stairs.
D. Powered hand tool may be used for upholstered furniture, draperies, mattresses, clothing, automobile interiors, and carpeted stairs.
E. Crevice wand may be used in tight spaces, corners and along edges in such places as dresser drawers, upholstered furniture, stairs and baseboards. It can also be used for extra reach with the dusting brush.
|
F |
Attach wand and tools
Attach tool to the hose (F) by push- ing it firmly onto hose.
Twist wand or tool slightly to tighten or loosen the connection.
|
Combination tool
Slide brush to remove.
To replace brushes, align brush with grooves on tool. Slide brush into place.
3. Maintenance
Familiarize yourself with these home maintenance tasks as proper use and care of your cleaner will ensure continued cleaning effectiveness.
A
Air flow indicator
The indicator (A) will show red when the dirt cup is full or there is a block- age or clog in the system. Turn cleaner OFF and unplug. Check the dirt cup and empty if necessary. Turn cleaner back on. If the indicator still shows red, follow the instruc- tions under “Clearing blockages”.
6
