Hoover Floor Mate with Spin Scrub Brushes The Hard Floor Cleaner Recovery Tank lower tank, 2-10

2-10

2.0 oz./60ml.

H

Turn cap (H) upside down to serve as a measuring cup.

2-11

2.0 oz./60ml.

Using cap, measure 2 oz. of applica- ble concentrate formulated for use with the ‘FloorMate’ hard floor cleaner.

For best results, use Machine Formula LYSOL® Floor Cleaning Concentrate when cleaning floor surfaces such as vinyl, ceramic and other tiles, and linoleum.

Use Machine Formula OLD ENG- LISH® Wood Floor Cleaning Concen- trate for wood floors when cleaning laminate wood, polyurethane sealed wood or other wood floors that can normally be cleaned using water.

Check for worn spots or joint separa- tions before using, as these condi- tions could lead to damaged flooring when using water to clean floor.

Both of these concentrates have been specifically formulated to resist excessive foaming and other undesir- able effects when used in your ‘Floor- Mate’ Cleaner.

DO NOT use cleaning concentrates that contain pine or solvent based ingredients.

CAUTION: Machine Formula LYSOL® Floor Cleaning Concen- trate and OLD ENGLISH® Wood Floor Cleaning Concentrate cannot be used in Hoover SteamVac™ products. Doing so could damage your SteamVac™ .

2-12

I

2-13

2.0 oz./60ml.

K

J

Pour cleaning concentrate into tank. Fill tank to fill line (I) (1 quart) with warm water.

If rubber ring (J) on cap has become dislodged, reposition it with uneven side against ledge (K) as shown.

2-14

2-15

Recovery Tank (lower tank)

The recovery tank holds both dry debris and dirty cleaning solution that is picked up from the floor surface.

Automatic Shut-Off

An automatic suction shut-off is built into the recovery tank to prevent the tank from overflowing.

When the shut-off activates, the clean- er will not pick up debris and the

Replace cap. Rotate cap clockwise	Position bottom of tank into cleaner.
until it locks in place. Cap must be	Press latch and snap tank into place.
locked in place for proper perfor-
mance and to prevent leaking.

sound of the motor will change.

There are two reasons the shut-off will activate.

1.Recovery tank is full - Turn the cleaner off and empty the recovery tank.

2.The handle was raised to the upright position while the motor was running - Turn cleaner off. Wait a moment for the shut-off to reset. Turn cleaner on and continue cleaning.

Continued 7