Hoover HDO 885, HDO 889 manual Operations to be carried out to make a new connection

•The electrical connection to the installation should be made via a socket with a plug with earth, or via an omnipole cut-out switch with an opening gap of at least 3 mm.

•The yellow/green wire of the power supply cable must be connected to the earth of both power supply and appliance terminals.

•Hoover cannot be held responsible for any accidents resulting from the use of an appliance which is not connected to earth, or with a faulty earth connection continuity.

•Any queries regarding the power supply cord should be referred to After Sales Service or a qualified technician.

•The yellow-green earthing cable must not be governed by the ON/OFF switch. The socket or the ON/OFF switch used for connecting to the power supply must be easily accessible when the oven has been installed.

•Important: During installation, position the power cable in such a way that it will not subjected to temperatures of above 50° C at any point.

•The cabling and wiring system must be able to bear the maximum electric power required by the oven. This is indicated on the specifications plate.

If you are in any doubt at all, use the services of a professionally qualified person.

•WARNING: the voltage and the supply frequency are showed on the rating plate

- Operations to be carried out to make a new connection:

•Choose the supply cord in accordance with the recommendations in the table

•The oven must be in situation as shown:

•Pass the supply cord into the clamp.

•Strip the end of each conductor of the supply cord a 10 mm length, by taking in account the cord for the connection on the terminal block.

•According to the installation and with the help of should have recovered in the first operation, fix the conductor as shown on the chart.

•Engage the earth wire yellow/green on the earth terminal, tighten the nut and verify the continuity of the earth.

•Secure the cable clamp.

•Fix the cover.