Hoover Power Nozzle warranty Power nozzle, Handle positions, Edge cleaning

Models: Power Nozzle

1 9
Download 9 pages 27.62 Kb
Page 4
Image 4
0• completely into cord receptacle underneath hand grip.

. Push plug on power nozzle cord

0completely into cord receptacle underneath hand grip.

Always disconnect cleaner from elec- trical outlet before attaching or removing power nozzle plug.

. For cleaners with plastic wands, Elsqueeze tabs on separate cord clip together while pressing cord into small slot (E).

Snap one cord clip (F) onto each exten- sion wand. Adjust cord, placing excess between nozzle and bottom cord clip.

aFor cleaners with metal wands,

position cord into cord clips (G) on wands, placing excess cord between nozzle and bottom cord clip.

Note: On models with wand storage clip, the bottom cord clip is on the wand storage clip.

To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.

After assembling cleaner, plug a cord into electrical outlet. Turn

cleaner on by depressing ON-OFF pedal (A). To turn cleaner off, depress pedal again.

qOn models without cord rewind pedal, release cord by rotating

cord hook (6) inward before depress- ing ON-OFF pedal (A).

Power nozzle

The power nozzle adjusts automatically for cleaning hard surface floors and vari- ous heights of carpets. It is not recom- mended for very irregular surfaces such as brick, slate, and certain par- quet floors unless it is unplugged from the cleaner. This will stop the agi- tator from rotating. If desired, a special wall/floor brush (shown in “Cleaning tools” section) can be purchased for this task, if it is not included with your model.

Handle positions

qThe handle has two positions when used with the power nozzle:

upright and operating.

To lower handle to operating position, place your foot on the power nozzle and pull handle back.

Edge cleaning

q, Brushed edge cleaning is provid- ed on both sides of the nozzle to remove embedded dirt in carpet near

baseboards and furniture. Guide either side of nozzle parallel to edge of carpet or furniture.

Page 4
Image 4
Hoover Power Nozzle Power nozzle, Handle positions, Edge cleaning, completely into cord receptacle underneath hand grip