Check bag indicator
(Available some models)
qThere are three conditions that will cause the indicator to become completely red:
1. The bag is full; change bag.
2.Very fine materials (such as powder) have been picked up, clogging the bag pores; change bag, even if it is not full.
3.There is a blockage in the nozzle, hose, tools or at the bag opening; remove the blockage.
Suction regulator
qThe suction regulator (C) is located ’ on the hand grip and may be used to increase or decrease suction for
various cleaning tasks.
If power nozzle is difficult to push on some carpet, open the suction regulator. This will prevent damage to the belt.
Cleaning tools
A variety of useful cleaning tools is included with your cleaner. If the clean- er you have purchased does not include the wall/floor brush, it is available at a nominal cost from your Authorized Hoover Dealer (Depot), a Hoover Factory Service Center or by writing to The Hoover Company, North Canton, Ohio 44720.
4*
Select the proper tool
q1. Crevice tool may be used in tight spaces, corners and along
edges in such places as dresser draw- ers, upholstered furniture, stairs and baseboards.
2.Furniture nozzle may be used for upholstered furniture, draperies, tapes- tries, mattresses, clothing, automobile interiors and carpeted stairs.
3.Dusting brush may be used for carved furniture, table tops, books, lamps, lighting fixtures, Venetian blinds, baseboards, shutters and registers.
•4. Wall/Floor brush may be used for walls and very irregular hard surface floors such as brick and slate.
*Included with some models.
Attachina tank
m Attach tools to handgnp and pIaS- w tic wands by rotating plastic latch ring until slots align; insert tool and
rotate ring to lock.
To remove tool, reverse above procedure.
_ For models with metal wands,
Tw attach tools to wand by pushing button projection on tool into spring
latch on wand. Depress center of latch t o r e m o v e .
Storing d4aaner
,
qThe cleaning tools are conveniently ’ stored in the cleaner, as shown. To
replace the wall/floor brush, be sure to turn the nozzle connector toward the cord hook or rewind pedal (B) before pushing the brush in place.
Continued I-
5
