E
F
G
H
Secondary filter
Disconnect cleaner from electrical outlet.
The secondary filter, located in the bag compartment, protects the motor from dirt particles.
Insert new filter into slots (E).
Do not operate cleaner without secondary filter in place.
Final filter
Disconnect cleaner from electrical outlet.
To change the final filter, press latch and remove filter door (F).
Discard old filter.
Insert tabs (G) on filter door into slots (H) on cleaner. Snap door closed.
Do not operate cleaner without filters in place.
It is recommended that the sec- ondary and final filters be replaced after every 5 bag changes.
Replace with Hoover bags and filters using HOOVER part no.
Where to buy
Bags and filters may be purchased from your local Authorized Hoover Dealers (Depots), Leading Retailers, Hoover Factory Service Centers, or through The Hoover Company online at www.hoover.com.
Lubrication
The motor is equipped with two bearings that contain sufficient lubri- cation for the life of the motor. The addition of lubricant could cause damage.Therefore, do not add lubri- cant to the motor bearings.
Thermal protector
Service
To obtain approved HOOVER ser- vice and genuine HOOVER parts, locate the nearest Hoover Factory
Service Center or Authorized Hoover Warranty Service Dealer (Depot) by:
•checking the Yellow Pages under “Vacuum Cleaners - Household” OR -
•checking the list of Factory Service Centers provided with this cleaner OR -
•checking the Service section of The Hoover Company online at www.hoover.com OR -
In Canada, contact Hoover Canada, Burlington, Ontario L7R 4A8, Phone:
Always identify your cleaner by the complete model number when requesting information or ordering parts. (The model number appears on the bottom of the cleaner.)
An internal thermal protector has been used in your cleaner to prevent overheating if a large item or clog gets caught in the nozzle or at the opening of the bag.
When the blockage is not removed, the thermal protector will trip and cleaner will stop run- ning.
If this happens, turn cleaner OFF and disconnect cleaner from elec- trical outlet. Then disconnect nozzle and remove obstruction. Within 20 minutes, the thermal protector will cool and automatically reset and cleaning may resume.
If cleaner does not operate, allow additional time for thermal protector to reset.
•calling
Please do not send your cleaner to The Hoover Company in North Canton for service, this will only result in delay.
If further assistance is needed, contact The Hoover Company Consumer Response Center, North Canton, Ohio 44720, Phone:
7