NOZZLE HOSE
The Nozzle Hose carries the dirt from the nozzle to the extension wand and to the throw away bag. If the hose becomes obstructed, cleaning effectiveness will sharply decrease. Remove bottom plate as de- scribed in preceding section, and slide end of hose out of the holder. Clear hose and reinsert into holder. Replace bottom plate as described in pre- ceding section.
AGITATOR BRUSHES
When brushes become worn and bristles do not ex- tend past the bottom plate of the nozzle, they should be replaced. Hold a straight edge across the bottom plate to check for length of bristles. Always replace both brushes at the same time to maintain cleaning effectiveness.
HOW TO REPLACE THE
AGITATOR BRUSHES
Disconnect the cleaner from electrical outlet and disconnect power nozzle from extension wand.
To replace worn brushes, remove bot- tom plate, belt and agitator, following directions given on page 11.
Turn end plates (Fig. 1) of agitator counterclockwise until one end plate comes off.
Then pry out end section as shown. (Fig. 2).
Pry out opposite end section, remov- ing the end plate and shaft from the agitator as illustrated. (Fig. 3).
14
