1
3
HOW TO REPLACE THE
BOTTOM PLATE BRUSH
Disconnect cleaner from electrical outlet and disconnect Powermatic nozzle from extension wand.
Put the Surface Selector Lever in the “Carpet” Position. This will allow for easier removal of the brush. Turn Power- matic nozzle over. Remove bottom plate by unscrewing the 2 Phillips head screws at the back of the nozzle. Fig. 1. Lift plate off to release from nozzle housing.
Turn inside of the bottom plate up. Care- fully slide brush out of holders. Fig. 2.
With the Surface Selector Lever still in the “Carpet” position, slide new brush into holders one at a time supporting the holder as you slide in the brush. Fig. 3. Center brush in bottom plate opening by sliding brush in holders as necessary.
Run a thin utensil such as a table knife around the brush to make certain all the bristles enter the slot in the bottom plate. Fig. 4.
Replace bottom plate by fitting the plate over the lip at the front of the nozzle hous- ing. Line up the slots over the wheels and position holes in bottom plate over screw mountings. Fig. 5. Replace screws.
16
