.
1
If you have a problem
This appliance was inspected thoroughly and was in good operating condi- tion when it was shipped from the factory. If a minor problem occurs, it usually can be solved quite easily when the cause is found. Therefore, this check list is provided to assist you.
| Problem |
| Possible cause |
|
| Possible solution |
| ||
|
| A. Cleaner | 1. | Not firmly plugged in. | 1. Plug unit in firmly. | ||||
t won’t run | 2. | No voltage in wall plug. | 2. | Check fuse or breaker. | |||||
|
|
| 3. | Blown fuse/tripped | breaker. | 3. Replace fuse/reset breaker. | |||
|
|
| 4. | Thermal protector | tripped. | 4. | See thermal protector | ||
|
|
|
|
|
|
| section. (pg. 9) |
| |
|
| B. Cleaner 1. Bag full. |
| 1. | Change paper bag. | ||||
|
| suction | 2. | Bag not opening. |
| 2. | Open bag by pulling folds. | ||
|
| low | 3. | Obstruction in hose, wands, | 3. | Remove foreign object. | |||
|
|
|
| or nozzle connector. | 4. Clean filter. | ||||
|
|
| 4. | Secondary filter dirty. | |||||
|
|
| 5. Suction regulator |
| 5. Set suction regulator | ||||
|
|
|
| lmproperlv set. |
|
| properly. |
| |
|
| C. Nozzle | 1. | Low cleaner suction. | 1. See Item B | ||||
|
| won’t | 2. Obstruction in nozzle | 2. | Remove foreign object. | ||||
|
| pick up |
| connector. |
| 3. | Replace nozzle brush. | ||
|
|
| 3. | Nozzle brush worn. | |||||
|
|
|
|
|
|
|
|
|
|
Service
If the problem persists, check the Yellow Pages of your telephone book under “Vacuum
Do not send your cleaner to The Hoover Company in North Canton for service as this will only result in a delay.
Always identify your cleaner by the complete model number when requesting information or ordering parts. (The model number appears on the bottom of the cleaner.)
If further assistance is needed, contact The Hoover Comapny, Consumer Affairs Department, North Canton, Ohio
1 1
