3 - 14 | 3 - 15 |
3 - 16
E
Lift up end of agitator brush roll. Remove
F
Stretch belt back and attach to motor
C
Replace brush roll cover (C) over agitator
old belt from agitator pulley (E) and
pulley.
replace with new belt. Lettering on belt
must be visible.Hold opposite end of agitator brush ro l l in place. Push belt end forw a rd, ro t a t i n g
end plate (F) until it slides into place.
Tu rn agitator, making sure it rotates fre e l y.
b rush roll. Replace 3 short scre w s .
3 - 17
Position hood on top of nozzle base.
Tu rn nozzle over. Replace 2 short scre w s at the back of nozzle and 2 long scre w s at the fro n t .
3 - 18
Agitator brush roll replacement
When to replace
Disconnect cleaner from electrical outlet.
When agitator brush roll brushes are
w o rn, the brush roll should be re p l a c e d .
To check condition of brushes, move edge of a card across bottom plate while t u rning brush roll. To maintain cleaning e ffectiveness, replace brush roll if bru s h- es do not touch card .
What to buy
When purchasing a new agitator bru s h roll, ask for HOOVER p a rt no.48414- 0 7 1 .
How to replace
Disconnect cleaner from electrical outlet.
1.Remove hood, duct cover, belt and b rush roll as shown in Figs.
3- 1 4 .
2.Discard old brush ro l l .
3.Replace new brush roll and belt as shown in Figs.
Headlight re p l a c e- m e n t
The headlight, located on top of the power nozzle, operates when the clean- er is turned on. Use only HOOVER part no. 27317307, which is a fused bulb, when replacing the headlight.
How to replace
Disconnect cleaner from electrical outlet and disconnect power nozzle from extension wands.
1.Remove the hood as shown in Figs.
3 - 19
2.Push old bulb into socket and twist to remove. Push new bulb into socket and twist into place.
3.Replace hood.
Thermal protector
An internal thermal protector has been used in your cleaner to prevent over- heating if a large item or clog gets caught in the nozzle or at the opening of the bag.
When the blockage is not removed, the thermal protector will trip and cleaner will stop running.
If this happens, turn cleaner OFF and disconnect cleaner from electrical outlet. Then disconnect nozzle and remove obstruction. Within 15 minutes the thermal protector will cool and auto- matically reset and cleaning may resume.
If cleaner does not operate, allow addi- tional time for thermal protector to reset.
10
