Powered hand tool | 3 - 28 |
|
Belt replacement | F | E |
Inspecting the belt
The powered hand tool belt is designed to last a long time and is not normally replaced. However, if the belt is cracked, gouged or broken, it should be replaced.
3 - 29
H
G
3 - 27
The belt can be seen through the top of the nozzle or by removing the bottom plate and belt guard (Figs.
Replacing belt
When replacing belt, ask for HOOVER part no. 38528037.
1.Remove bottom plate, belt guard and brush roll as described in Figs.
2.Grasp turbine (E) and pull firmly to remove.
3.Remove belt from turbine pulley (F). Replace with new belt.
4.With flat sides of turbine retainers (G) pointing down, slide retainers into grooves (H) on both sides of tool hous- ing and snap into place.
5.Replace brush roll, belt guard, and bottom plate as described in Figs.
Lubrication
The motor is equipped with two bear- ings that contain sufficient lubrication for the life of the motor. The addition of lubricant could cause damage.
Therefore, do not add lubricant to either motor bearing.
The agitator brush roll is equipped with two ball bearings that should be lubri- cated periodically by a Hoover Factory Service Center or an authorized Hoover Warranty Service Dealer (Depot).
Service
To obtain approved HOOVER service and genuine HOOVER parts, locate the near- est Hoover Factory Service Center or
Authorized Hoover Warranty Service Dealer (Depot) by:
•checking the Yellow Pages under “Vacuum Cleaners - Household” OR -
•checking the list of Factory S e rvice Centers provided with this cleaner OR -
•calling 1 - 8 0 0 - 9 4 4 - 9 2 0 0 for an automated re f e rral of authorized s e rvice outlet locations (U.S. only) O R -
•checking the Service section of The Hoover Company online at www.hoover.com
Please do not send your cleaner to The Hoover Company in North Canton for ser- vice, this will only result in delay.
If further assistance is needed, contact The Hoover Company Consumer Response Center, North Canton, Ohio 44720, Phone:
In Canada, contact Hoover Canada, Burlington, Ontario L7R 4A8, Phone:
Always identify your cleaner by the com- plete model number when requesting information or ordering parts. (The model number appears on the bottom of the cleaner.)
12
