Hoover U6049 manual To Replace Brushes

!Replace agitator and latch it in posi-

I tion. (Fig. 4).

Make sure that large belt is in center of pulley, and free of agitator mount- ings and latch. Turn agitator by hand to be sure that belt is in proper posi- tion. (Fig. 5).

Replace bottom plate. (Fig. 6). Make
sure that clips enter into the recesses
on the cleaner bottom plate. Check
to see that latches are pushed back
and will not be covered by plate. (Fig.
6). Place plate in position and latch
securely. Turn agitator by hand to be
sure that belt is in proper position on	6
pulley.

1 Brushes

When brushes are worn and bristles do not touch the edge of a card held across the nozzle, they should be replaced. (Fig. 1). Always replace both brushes at the same time to maintain cleaning

effectiveness.

I/

TO REPLACE BRUSHES

Remove bottom plate, belt and agita- tor following directions on Page 11.

Turn end plates (Fig. 2) of agitator in

opposite direction.

I 11