SETTING UP + INSTALLATION
1
2 
Remove the polystyrene base and place the machine near its permanent position (diagram 1).
Carefully cut through the hose retaining clip at the rear of the appliance (diagram 2).
Remove the 4 fixing screws marked (A) and remove the 4 spacers marked (B) (diagram 3).
Cover the 4 holes using the caps provided in the instruction booklet pack (diagram 4).
3 | 4 |
WARNING:
DO NOT LEAVE THE PACKAGING WITHIN REACH OF CHILDREN AS IT IS A POTENTIAL SOURCE OF DANGER.
Apply the insulation sheet of corrugated material to the base as shown.
Use the 4 feet to level the machine with the floor:
a)Turn the nut clockwise to release the screw adjuster on the foot.
b)Rotate the foot to raise or lower it until it stands firmly on the ground.
c)Lock the foot in position by turning the nut
A |
B |
C |
28
