1. AssemblyCarton contents
Remove parts from tank and identify the following:
A. Cleaner tank
B. Cleaner lid and motor housing or cleaner lid and motor hous ing (Supreme 12.5 gallon)
A
F
D
G
K
E
B
H
B
I
J
C
L |
C.Hose
D.Caster supports (4)*
E.Casters(4)
F.Wet/Dry nozzle
G.Squeegee insert *
H.Paper filter
I.Foam filter
J.Mounting ring
K.Extension wands (2)
L.Caster support screws (4)*
*included with some models
A
3
B
1
2
|
|
|
| |
A | B | C | D | E |
Attach casters
(standard models)
Remove cleaner lid. Turn cleaner tank upside down (A).
Insert caster stem into hole on bottom of tank. Press firmly until caster snaps into place.
Repeat with remaining casters. Turn cleaner tank right side up.
Attach caster supports and casters
(supreme models)
Remove cleaner lid. Turn cleaner tank upside down (B).
Align square tabs (1) on caster supports (3) with rails (2) on tank. Slide tabs onto rails and press caster support down firmly. Insert support screw into hole nearest tank. Tighten screw with a Phillips screwdriver.
Insert caster stem into hole on bottom of caster support. Press firmly until caster snaps into place. Repeat with remaining casters. Turn cleaner tank right side up.
Attach filters
Disconnect cleaner from electrical outlet before attaching or removing filters.
NOTE: Do not attempt to remove the filter cage or float ball. They are not removable parts.
For dry pick-up
Slide foam filter (B) over filter cage (A).
Slide paper filter (C) over foam filter. Make sure foam filter and paper filter are to top of filter cage.
Slide mounting ring (D) to top of filters. Ring will rest against ribs (E) in housing.
It is very important that the mounting ring (D) is pushed over the filters and all the way to the ribs (E), as shown in the illustration.
4
