23
Stair cleaning
23A stair cleaning handle has been designed for ease in using your
cleaner on stairs. With handle in oper- ating position, place fingers under the edge of stair cleaning handle and guide cleaner with the other hand on upper handle.
As an alternative, you may use the hose and furniture nozzle for stair cleaning. Clean from bottom to top.
When using cleaning tools, the agi- tator will continue to rotate.
C A U T I O N : To avoid personal injury or unnecessary wear to carpet, and to prevent the cleaner from falling, always place it a t bottom of stairs.
Cleaning tools
Tools allow for cleaning surfaces above the floor and for reaching hard to clean areas .
Suction will automatically be diverted to the hose when handle is in u p r i g h t p o s i t i o n and cleaner is turned ON.
CAUTION: Agitator continues to rotate while cleaner handle is in upright position. Avoid tipping cleaner or setting it on furniture, fringed area rugs or carpeted stairs during tool use.
How to clean tools
To clean hose, wipe off dirt with a cloth dampened in a mild detergent. Rinse with a damp cloth.
Cleaning tools may be washed in warm water with a detergent. Rinse and air dry before using.
24
AB
C
D
24 Select proper tool
A. Dusting brush may be
used for carved furniture, table tops, books, lamps, lighting fixtures, venetian blinds, baseboards, shut- ters, and registers.
B. Furniture nozzle may be used for upholstered furniture, draperies, mattresses, clothing, automobile interiors, and carpeted stairs.
C. Crevice tool may be used in tight spaces, corners and along edges in such places as dresser drawers, upholstered furniture, stairs and baseboards.
D. Wands are used to give extra length to your hose. Use them with any of the above tools.
25
A
26
B
C
D
Maintenance
Disconnect cleaner from electrical outlet before attempting to ser- vice it in any manner.
Do not operate cleaner without either cloth filter bag or paper fil- ter bag in place.
The cloth filter bag
Attach wand and tools
When using cleaning tools, cleaner should be in upright position. Also, turn cleaner OFF before dis- connecting and connecting hose to hose tube (A).
25To use hose, lift hose end as shown.Lower cover (B) on hose
tube.
When you are finished cleaning with the tools, be sure to lift cover from hose tube and reposition hose end into tube.
26Attach tool or wand to the hose (C) by pushing it firmly
into hose.
Attach second wand or tool to wand
(D)by pushing it firmly onto the wand.
Twist wand or tool slightly to tighten or loosen the connection.
When to empty
Check filter bag from time to time. It should be emptied often. If the filter bag is allowed to overfill, the cleaner will not operate eff e c t i v e l y.
6
