INTRODUCTION IMPORTANT PRECAUTIONS
P R E - A S S E M B LY
DO NOT CUT STRAPS UNTIL STEP
WARNING cardboard packaging that is not beneath the treadmill. Do not attempt to lift the
treadmill at this time. Remove plastic wrap from console masts.
A S S E M B LY STEP 1
A S S E M B LY STEP 2
HARDWARE BAG 2 CONTENTS : |
|
| A | Open HARDWARE BAG 2. | |
B | Lift CONSOLE (as shown) to lock | ||||
/65 $ | |||||
| NN | ||||
| 2UZ | NN |
| it into place. | |
| 2UZ |
| |||
|
|
|
| ||
|
|
|
|
| |
C Insert BOLT (B) through |
CONSOLE MAST and secure |
using NUT (C). |
IMPORTANT PRECAUTIONS INTRODUCTION
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
CONDITIONING TROUBLESHOOTING LIMITED
GUIDELINES & MAINTENANCE WARRANTY
HARDWARE BAG 1 CONTENTS :
BOLT (A) 45 mm Qty: 2
LINK ARM COVER
BOLT (A) | LOWER |
| LINKAGE |
| ARM |
AOpen HARDWARE BAG 1.
BLift left console mast into upright position. Be sure to hold the console mast firmly, as it will not stay in the upright position on it’s own.
CMove left side linkage arm into position. Insert bolt (A) and tighten.
DRepeat on the right side.
ENow cut the banding straps and remove remaining packaging material.*
*Note: If the straps have been removed before completing step
D Repeat on other side. |
Note: Do not pinch the wires. |
A S S E M B LY STEP 3 |
|
|
|
CONSOLE MAST COVER |
| HARDWARE BAG 3 CONTENTS : | |
|
|
| |
|
|
| BOLT (D) |
|
|
| 16 mm |
|
|
| Qty: 6 |
BOLT (D) |
| A | Open HARDWARE BAG 3. |
|
| B | Place CONSOLE MAST COVERS |
|
|
| over CONSOLE MASTS as shown. |
|
| C | Attach CONSOLE MAST COVERS |
|
|
| using 6 BOLTS (D). |
WATERBOTTLE | SAFETY KEY | D | Place WATER BOTTLE HOLDERS |
| |||
HOLDER |
|
| and SAFETY KEY into the correct |
|
|
| positions. It is now safe to plug |
|
|
| in your treadmill. |
YOU’RE FINISHED!
ASSEMBLY
BEFORE YOU BEGIN
TREADMILL OPERATION
LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES
1.3T_Rev.1.4.indd | 7/12/06 8:25:07 AM |
