Horizon Fitness CT5.0 manual S E M B Ly C O N T I N U E D

INTRODUCTION IMPORTANT PRECAUTIONS

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL OPERATION

A S S E M B LY STEP 2 ( C O N T I N U E D )

HARDWARE BAG 2 CONTENTS:

BOLT (D)	FLAT WASHER (E)	WAVY WASHER (F)	LOCK LATCH PIN (G)
Qty: 1	27 mm	29 mm	Qty: 1
	Qty: 1	Qty: 1

	MAIN FRAME	CONSOLE CABLE	RIGHT CONSOLE MAST
		WAVY WASHER (F)	FLAT WASHER (E)
			BOLT (D)
			PRE-ATTACHED NUT
			RIGHT LINKAGE ARM
PRE-ATTACHED
TEFLON WASHER		PRE-ATTACHED BOLT
ELEVATION FRAME
	FOOT LOCK LATCH

A S S E M B LY STEP 3

HARDWARE BAG 3 CONTENTS :
BOLT (H)	SPRING WASHER (I)	FLAT WASHER (B)
20 mm	15 mm	20 mm
Qty: 4	Qty: 4	Qty: 4

CONSOLE CABLE

CONSOLE

DO NOT ATTACH

THIS SIDE UNTIL STEP 3-D

CONSOLE MAST

FLAT WASHER (B)

IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL OPERATION

CONDITIONING TROUBLESHOOTING LIMITED

GUIDELINES & MAINTENANCE WARRANTY

10

AInsert 1 bolt (D) and 1 FLAT washer (E) through RIGHT console mast followed by 1 WAVY washer (F) and attach to MAIN FRAME.

BUnscrew PRE-ATTACHED NUT and remove from RIGHT LINKAGE ARM and discard. Carefully move right linkage arm and PRE-ATTACHED TEFLON WASHER into position and attach to ELEVATION FRAME.

Note: While holding RIGHT CONSOLE MAST in the upright position, tighten PRE-ATTACHED BOLT using T-wrench to attach RIGHT LINKAGE ARM.

CCut band holding FOOT LOCK LATCH assembly. Lift the running deck until lock latch on side of treadmill is fully engaged.

DRemove console from box and place out of the way.

ELower the treadmill running deck from the folded position by stepping on LOCK LATCH on lower right side.

*Note: If you have attempted to move the treadmill from the box and the machine has sprung open and cannot be assembled, refer to the troubleshooting section in order to restore the treadmill to its proper position.

1

3

2

SPRING WASHER (I)

BOLT (H)

AOpen HARDWARE BAG 3.

BWith running deck in lowered position, place console on the console masts. Align the brackets that are underneath the console with the top holes of the console masts.

CTo assemble the CONSOLE to the left CONSOLE MAST, insert 1 BOLT (H), 1 SPRING WASHER (I) and 1 FLAT WASHER (B) into the 2 holes in the left CONSOLE mast and lightly tighten.

DGently lift right side of the console to connect the console cable. Carefully tuck wire in mast to avoid damage. NOTE: Do not pinch console cable or grip pulse wires.

ERepeat step C above to assemble the right console mast to the console.

11

LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES

CT5.0_Rev.1.1.indd 10-11 6/3/08 8:39:41 AM