INTRODUCTION |
|
|
IMPORTANT |
PRECAUTIONS |
P R E - A S S E M B LY
DO NOT ATTEMPT TO LIFT THE TREADMILL!* Do not move or lift treadmill
WARNING from packaging until specified to do so in the assembly instructions. Failure to do so may result in injury! Remove plastic wrap from console masts.
Note: During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware. Any grease, such as lithium bike grease is recommended.
A S S E M B LY STEP 2
HARDWARE BAG 2 CONTENTS :
BOLT (D) | FLAT WASHER (E) | WAVY WASHER (F) | LOCK LATCH PIN (G) |
Qty: 1 | 27 mm | 29 mm | Qty: 1 |
| Qty: 1 | Qty: 1 |
|
IMPORTANT PRECAUTIONS INTRODUCTION
ASSEMBLY |
|
|
YOU |
BEFORE |
BEGIN |
|
|
TREADMILL OPERATION |
|
A S S E M B LY STEP 1
HARDWARE BAG 1 CONTENTS :
BOLT (A) | FLAT WASHER (B) | TEFLON WASHER (C) |
15 mm | 20 mm | 18 mm |
Qty: 1 | Qty: 1 | Qty: 1 |
BOLT (D) | FLAT WASHER (E) | WAVY WASHER (F) |
Qty: 1 | 27 mm | 29 mm |
| Qty: 1 | Qty: 1 |
MAIN FRAME |
LEFT CONSOLE MAST |
WAVY WASHER (F) |
FLAT WASHER (E) |
BOLT (D) |
MAIN FRAME |
RIGHT FOLDING FRAME |
LOCK LATCH PIN (G) |
A Open Hardware Bag 2.
LEAD WIRE |
RIGHT CONSOLE MAST |
CONSOLE CABLE |
ASSEMBLY
BEFORE YOU BEGIN
TREADMILL OPERATION
GUIDELINES |
|
| |
CONDITIONING |
|
| |
|
| ||
&MAINTENANCE |
|
| |
TROUBLESHOOTING |
|
| |
|
| ||
LIMITED |
|
| |
WARRANTY |
|
| |
|
| ||
|
|
| |
LEFT LINKAGE ARM |
|
BOLT (A) | ELEVATION FRAME |
FLAT WASHER (B) |
|
TEFLON WASHER (C) |
|
AOpen HARDWARE BAG 1.
BCut banding straps. Do not move or lift treadmill from packaging.
CMove left linkage arm into position. Insert 1 bolt (A) and 1 FLAT WASHER (B) into left linkage arm followed by 1 teflon washer (C) and attach to elevation frame.
DLift left console mast into upright position. Be sure to hold the console mast firmly, as it will not stay in the upright position on its own.
EInsert 1 bolt (D) and 1 FLAT washer (E) through left console mast followed by 1 WAVY washer (F) and attach to MAIN FRAME.
BAttach LOCK LATCH PIN (G) into RIGHT FOLDING FRAME using
CPull LEAD WIRE through RIGHT CONSOLE MAST. After pulling the lead wire through the mast, the top of the console cable should be located at the top of the mast. Detach and discard lead wire.
DContinue step 2 on next page.
LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES
GS_1040T_Treadmill_Rev.1.7.indd | 4/3/08 9:13:21 AM |
