Horizon Fitness GS 1040T S E M B Ly, Unpacking, Tools Included, Parts Included, Console Assembly

INTRODUCTION

IMPORTANT

PRECAUTIONS

ASSEMBLY

A S S E M B LY

IMPORTANT: READ THESE SAFETY INSTRUCTIONS BEFORE USE!

WARNING

During the assembly process of the treadmill there are several areas that special attention must be paid. It is very important to follow the assembly instructions correctly and to make sure all parts are firmly tightened. If the assembly instructions are not followed correctly, the treadmill could have frame parts that are not tightened and will seem loose and may cause irritating noises. There should be no side-to-side play in the console masts or any forward and back play in the console assembly or handlebars. If there is any play in these areas, the treadmill has not been properly assembled. To prevent damage to the treadmill, the

READING RACK SPEAKERS

WATER BOTTLE HOLDER

CONSOLE

FAN

	SAFETY KEY PLACEMENT
GRIP PULSE HANDRAILS
HANDLEBAR	CONSOLE MAST

MOTOR COVER

FOOT LOCK LATCH ON/OFF SWITCH

CIRCUIT BREAKER POWER CORD

IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY

YOU

BEFORE

BEGIN

assembly instructions must be reviewed and corrective actions should be taken.

UNPACKING

Place the treadmill carton on a level flat surface. It is recommended that you place a protective covering on your floor. Take CAUTION when handling and transporting this unit. Never open box when it is on its side. Once the banding straps have been removed, do not lift or transport this unit unless it is fully assembled and in the upright folded position, with the lock latch secure. Unpack the unit where it will be used. The

TRANSPORT WHEEL

FLEXZONE™ ADJUSTABLE CUSHIONING

RUNNING BELT / RUNNING DECK

SIDE RAIL

ROLLER END CAP

REAR ROLLER

ADJUSTMENT BOLTS

BEFORE YOU BEGIN

TREADMILL OPERATION
GUIDELINES
CONDITIONING
&MAINTENANCE
TROUBLESHOOTING
LIMITED
WARRANTY
	

enclosed treadmill is equipped with high-pressure shocks and may spring open if mishandled. Never grab hold of any portion of the incline frame and attempt to lift or move the treadmill. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!

Before proceeding, find your treadmill’s serial number and model name located under the deck on the frame crossbar and enter it in the space provided below.

Enter your serial number and model name in the boxes below:

SERIAL NUMBER:

MODEL NAME:

*Refer to the serial number and model name when calling for service.

*Also enter this serial number on your Warranty Card.

TOOLS INCLUDED

c5 mm T-wrench

c6 mm T-wrench

(Used to adjust the rear roller adjustment bolts.)

c10 mm L-wrench

PARTS INCLUDED

c 1 Console Assembly		c 1 Audio Adaptor Cable
(located under treadmill deck)		c 1 Safety Key
c 2 Console Masts
c 2	Handlebars
c 4	Hardware Bags
c 1	Bottle of Silicone Lubricant
c 1	Power Cord

If you have questions or if there are any missing parts, contact Customer Tech Support.

Contact information is located on the back panel of this manual.

For a complete exploded diagram, visit us at www.horizonfitness.com



TREADMILL OPERATION

LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES

GS_1040T_Treadmill_Rev.1.7.indd 6-7 4/3/08 9:13:12 AM